Set up the home phone

Install Orb Relay on the phone with your SIM, give it the access it needs, and link it to your OrbVPN account.

The home phone is the Android phone that holds your SIM and stays at home. You need to be holding it for this part. After that it runs by itself.

What you need

  • A paid OrbVPN plan on your account.
  • An Android phone with the SIM in it. A dual-SIM phone shares both lines.
  • A place where it can stay switched on, charging, and connected to Wi-Fi or mobile data.

1. Install Orb Relay

Get Orb Relay from the Orb Relay page and install it on the home phone.

2. Give it the access it needs

Android asks before Orb Relay can use the SIM. Orb Relay shows what is still missing on its first screen, under Needs attention.

AccessWhat it is for
SMSReading the SMS that arrive, and sending the ones you write in Orb Remote
PhoneTelling the SIMs apart, seeing calls, placing calls, answering and ending them
Call logSeeing the number of a caller
NotificationsShowing that the phone is sharing. Without them nothing is shared (see below)
BatteryRunning in the background. Tap Turn off optimisation when Orb Relay asks, or Android may stop it after a while

There are two ways. Use whichever is easier.

By signing in on the home phone

  1. Open Orb Relay and tap Sign in with OrbVPN. The sheet that opens explains, above the email and password fields, what linking does: every SMS the phone receives from now on, and every call's number and time, are shared with the phones you connect; those phones can send SMS and place calls from this SIM; and the phone shows a notice for as long as it shares.
  2. Enter your OrbVPN email and password, and your two-step code if your account has one.
  3. Tap Sign in and link.

Your password goes to OrbVPN and is not kept on the phone. Once the phone is linked it is signed out of your account again and keeps only a key of its own, which opens nothing else in your account.

If you sign in to OrbVPN with an emailed link and have no password, either set a password first or use the camera method below.

By the camera, with no password on the home phone

  1. On the phone you carry, sign in to Orb Remote and choose Add a handset. It shows a QR code.
  2. In Orb Relay on the home phone, tap Scan a code from Orb Remote and point the camera at that code.
  3. The home phone shows which OrbVPN account the code is for, as OrbVPN holds it, and explains what linking does. Go on only if that account is yours, and tap Link to this account.

The QR code works for one home phone, within ten minutes. Orb Relay reads it only through its own camera screen: a link in a message or on a web page cannot start this. When you link this way, Orb Remote on the phone that showed the code is connected to the home phone at the same time, so you can skip the next page.

4. Check the switches

In Orb Relay's settings there are three switches, all on from the moment of linking:

  • Share SMS and calls. Off: nothing leaves the phone, and what arrives while it is off is not sent later.
  • Let my phones send SMS. From this phone's SIM. Your mobile plan's charges apply.
  • Let my phones place and answer calls. The call happens on this phone, and its sound stays here.

Good to know

  • SMS that were already on the phone before you linked it are never read or sent. Sharing starts at the moment of linking.
  • While it shares, the home phone shows a notification naming your OrbVPN account, and once a week a reminder. If Orb Relay's notifications are turned off, it shares nothing until they are back on.
  • An account can have up to 3 home phones.

Only your own phone

Link only a phone that is yours, with your own SIM, to your own account. See Only for your own SIM.

Next: Connect your phone.